Safety Pins 1 1/4 inch
Sea Glass Beads- any colour- I mixed mine, you can use any pattern or even a solid all throughout *** I got these at the dollar store
Elastic Cord- I bought black
1. Open safety pins and string beads on to the safety pin. It should be full and be able to close.
2. Cut two pieces of cord. Make sure it is long enough to wrap around your wrist and than add a couple of inches.
3. Tie one piece of cord at one end of the safety pin and the second at the other end of the safety pin.- SEE IMAGE
4. Continue to string the safety pins on to the two pieces of cord. Reverse the safety pins so they are not all running the same was- See image
5. Once you reach the desired length loop the cord through the first safety pin and knot off on the inside of the bracelet.
6. Trim and extra cord.
7. If you want to be sure the knot will not come loose you can use hot glue and glue the knot
No comments:
Post a Comment